Occasionally the salt indicator on the pentair intellichlor will not match the actual salt level of the pool.
Intellichlor ic40 cell light not on.
Caution the intellichlor ic15 power supplymust be interconnected with pool pump motor power source.
The intellichlor ic15 power supply fuses must only be obtained from the manufacturer.
But i have added salt and used salt testing kit and it shows salt at 3740ppm.
The following steps will provide a guide on how to recalibrate a pentair intellichlor.
When the intellichlor scg ic15 is installed in europe.
Intellichlor salt light shows red low salt and cell light is off.
If this is the case the salt level on the cell will need to be recalibrated.
The salt level indicator lights both the red and the green do not seem to be operating.
Same sanitation performance as manual chlorine addition without the drawbacks.
That means that the pentair ic40 life is running out limited life remaining under proper operation the intellichlor should provide at least 10 000 hrs.
It is connected to a timer for 7 hours 10am to 5pm.
Intellichlor uses common table salt to produce all the chlorine a pool needs safely effectively and automatically.
Also i checked the usage by pressing the more button for 3 seconds and it tells you how many hours have been used.
Electronic chlorine generator model ic60 ic40 ic20 and ic15.
I cleaned the cells by disconnected the ic40 unit and using cell cleaning solution purchased from my local pinch a penny and soaking the unit for about 15 minutes.
Turn on the heater or lay a solar blanket over the surface of the water if the cell light is red which indicates the water temperature has fallen below 52 degrees fahrenheit.
A few days ago i observed that the lights were not working.
It read 60 which means 6000 hours and the chlorinator only has a life of 10 000.
I had a pentair intellichlor ic40 installed last summer.
Intellichlor recommends read more.
No need for customers to buy transport and store chlorine compounds.
If i power the system down and then back up the red read more.
All other lights are green.
The cell light is off and will not come on even with the output at 100.
This ensures the intellichlor scg and pool pump will switch on and off together.
So its not producing chlorine.
The salt level is steady red low.
Some of the most experienced problems with pentair ic40 include.
This guide is only intended for versions 1 9 and below.
