Install Welded Wire Fence T Post

The standard tried and true metal t posts are the most commonly used but if you would like something more attractive than the green metal posts or are using the fence to enclose livestock and want to use electric fencing there are better options.

Install welded wire fence t post.

Welded wire is generally made of material that will not rust rot or burn. Attach the fencing to the first corner t post beginning at the top. Unroll the fence to the opposite corner or end post and attach it to the post with 1 1 2 inch galvanized fence staples. You should space your posts 8 12 feet apart as a general rule although 10 12 feet apart is sufficient for 5 6 wire barbed fence.

Position each post with the anchor plate at the bottom and perpendicular to the fence line. Use the t post driving tool. Install welded wire fence. To prevent sagging staple the mesh to the top rail every 3 inches temporarily leaving the bottom unattached.

Tie the wire to the pole. Welded wire fences can vary in size from 3 feet tall to 6 feet tall. Including stretching attaching and combining. Starting at a corner attach the end of your roll of welded wire.

Pull the fence taut. Once the roll is attached carefully unroll and stretch the wire to the next post. Most welded wire fence is installed using t posts but not all t posts are created equal. It is a special weighted pipe that slides up and down on the top section of a t post forcing the post into the ground.

Simply lift the tool and let go gravity and the weight of the tool will work to drive the t post in. Studs should face either inward or outward depending on whether it s more important to keep livestock in or predators out. Wrap a wire clip around the back of the t post place the ends of the clip around the wire on either side of the post and squeeze the ends of the wire clip to make tight fits around the fencing. Tips for installing a residential welded wire fence.

Each post should be driven into the ground until the flared fins are beneath the surface. Align the end of the mesh with the edge of the post and attach it to the post with fence staples. Use the baling wire or metal ties to tie the wire to the post at the top the middle and the bottom.