Install Laminate Stair Nose Moulding

Stair tread gauge http amzn to 2i3slng subscrib.

Install laminate stair nose moulding.

Versatrim s list of profiles include three pvc moldings for lvt floors slim trim versaedge slim cap and their standard laminate t moldings reducer end cap square nose stair nose bull nose wall base baseboard colonial base quarter round base shoe shoe mold profiles. Install the metal track on the stair nose with the liquid nails glue. Thick x 2 1 8 in. Zamma cross sawn oak grey 3 4 in.

Things i mention in this vid. Allow time for the glue to dry by following the guidelines on the tube of glue. The main objective when cutting stair nose molding and installing it is to cut the stair nose as tight as possible to fit on each side. Length laminate stair nose molding 32 98.

Stair tread and nosing installation. Install the track just close enough to the edge of the stair nose to allow the edge of the stair case molding to hang over. Stair nose molding is used in conjunction with a hardwood floor installation to finish off the step or stairwell where the hardwood floor stops. Watch installing laminate on stairs.

Install the molding track by gluing screwing or nailing it 3 4 from the edge of the stair tread apply construction grade adhesive to the stairnosing where the. The molding sits against the stair tread while overlapping the front of the step to give it a nicely rounded decorative look. This applies to laminate stair nose as well as hardwood stair nose. Stairnose the stairnosing is used to finish stair treads and risers which have been fully adhered to the floor using a shaw approved multipurpose flooring adhesive stop the flooring about 1 1 2 from the step s edge.

Stair nose moldings pergo simple solution stairnose enhances the overall beauty of the staircase or step down while acting as a protective strip for the flooring along the leading edge. And to have it set level on the edge of the stair. Installation of the stair nose trim is quick and simple with the molding held in place primarily with adhesive and a bit of additional support from wood screws. This is accomplished by cutting the riser flush with the top of the step.