It is used to create uniform flow into wide parts purpose 1.
Injection mold fan gate design.
Used in large size molded product.
This is only possible how ever for certain materials such as thermoplastic elastomers.
Normally used with thin wall parts.
If unavoidable the weld marks should be designed on the unimportant surface and non weak parts of.
Their location quantity shape and size etc.
It has the following advantages.
Plastic injection molding fan gate design 4.
It is used for the plastic part of a large area.
Used like the disk gate.
Position number shape and size of the gate have a direct impact on the quality and the appearance of the product and therefore in the design process attention is required for gate style.
Gate is a passage way from the subrunner to the mold cavity and its cross section is the smallest and shortest part in the injection system.
Ring part must get filled first and then the cylinder part otherwise the weld will occur.
1 injection molding gate is a small opening between the runners and the mold cavity.
The gate architecture and its location affects cycle times tooling costs lead times the location of witness marks and many other potential defects that are commonplace for injection molded parts.
Its structure is similar to the side gate but gate width is bigger and fan shaped.
The purpose is to make the gate position of the mold consistent with the center of the mold to avoid the gate offset of the mold.
Plastic injection molding tab gate design 3.
Normally used with multi cavity two plate molds.
Design fan gate is similar to the side gate but width of gate is bigger and has fan shaped.
Used in large size molded product.
Figure 6 2 curved sprue 6 3.
It permits rapid filling of large parts or fragile section mold area with large entry area.
Fan gate is a gate spreading toward in to cavity basically this gate is thin similarly with previous gate and is used in same purpose with film gate.
2 the gate size is dependent on product weight material and gate types.
Plastic injection molding fan gate design.
6 2 the edge or fan gate an edge gate is primarily used for molding parts with large surfaces and thin walls.
Since the curved core is subjected to the injection force the core is pushed to the opposite side so that the pipe cannot be molding.
But the test results show that.
Pinpoint or restricted gate a restricted opening between the runner and molded part.
You can read all the content.
If the injection molding requirements meet the smaller the number of gates are the better it is it would reduce the weld marks.
Fan or edge gate a common gate located in the sidewll of the part to prevent restriction of resin flow.
With the gate construction it permits rapid filling of large parts or fragile section mold area with large entry area.
Molded part in the mold which is now loaded in the center.
The runner and gate system used in plastic injection molding is responsible for directing molten plastic from the nozzle of the molding machine into the cavity of the tool.
It is used to create uniform flow into wide parts.
Thereby keeping the cross sectional area constant.
